TIME TO BUILD A DIY DRONE
To build a drone first you need to have the right parts. There is a list below ↙. And for this project you will need to use a soldering iron. Just keep that handy.
Drone Parts
1. Power distribution board
2. Frame
3. Battery and charger
4. 4X ESC's
5. 4X Brushless motors
6. 4x propellers
7. Flight computer
8. transmitter and receiver
Power distribution board distributes power to the whole drone. It takes power from the battery and sends it to every single part of the drone that needs power.
Frame is the body of the drone. Everything is attached to the frame.
Battery is the source of power for the drone. And you will need a charger to charge the battery so the drone can use that power to fly.
ESC is an electronic speed controller. It controls the speed of the rotation of the propellers. You need four of them because each propeller has to spin in a different direction to maintain balance.
Brushless motors spin the propellers and push the drone upwards.
Flight computer tells the parts of the drone what to do. It gets the information from the receiver and processes it and then sends it to the ESCs and to other parts.
The transmitter is the remote control. It sends information to the receiver that is on-board the drone. And the receiver tells the flight computer what to do.
Drone Parts
1. Power distribution board
2. Frame
3. Battery and charger
4. 4X ESC's
5. 4X Brushless motors
6. 4x propellers
7. Flight computer
8. transmitter and receiver
Power distribution board distributes power to the whole drone. It takes power from the battery and sends it to every single part of the drone that needs power.
Frame is the body of the drone. Everything is attached to the frame.
Battery is the source of power for the drone. And you will need a charger to charge the battery so the drone can use that power to fly.
ESC is an electronic speed controller. It controls the speed of the rotation of the propellers. You need four of them because each propeller has to spin in a different direction to maintain balance.
Brushless motors spin the propellers and push the drone upwards.
Flight computer tells the parts of the drone what to do. It gets the information from the receiver and processes it and then sends it to the ESCs and to other parts.
The transmitter is the remote control. It sends information to the receiver that is on-board the drone. And the receiver tells the flight computer what to do.
The build begins
First, attach the motor to the frame of the drone. Then take the Power distribution board and attach that to the frame in the drone center. Then take the ESC's and solder them to the Power distribution board. On the Power distribution board there will be written ESC 1, ESC 2, ESC 3, and ESC 4. Once you finished the motor will have 3 plugs. Plug in the the motors in to the ESC's then take the flight computer and solder it to the Power distribution board. Then take the receiver and solder that also to the Power distribute board. Then you are almost ready to fly but first you might have to program the drone but it depends if you buy the parts programmed or not and before you fly the drone you want the propellers spinning correctly. To make the motor spin a different direction just switch the cables. When you finished programming and got the propellers spinning correctly, then we have liftoff!!! 
Comments
Post a Comment